Repetier server port7/30/2023 In that case disable reset on connect, so the host does not have to wait for the start signal which will never come. incomplete line, resend expected) you might get errors at the connection. the connection was stopped in an error state (e.g. The reset is used to get a clean starting point, so we know firmware is ready to respond. Some boards like printrboard do not support reset over DTR signal. It only means you are connected with the usb-serial converter of your printer board. Having a connection does not mean, that you can communicate. If no new port appears, you need to install the driver first. You can of course also do it the other way around. If the port vanishes for the dropdown list (the seleced port will not disappear, even if it is not available), you had the right port. If you are not sure if it is the right port, unplug the printer and click on “Refresh Ports”. These ports are only visible, if the printer is connected! So connect your printer and select the port. In the printer settings you have a dropdown list to select the port of your printer. Only if you select the com port of your printer, you are able to connect, if no other program is connected to the printer (eg Repetier-Server). You should be aware of the three stages of the connection and first find out, at which stage your problem occurs. One frequent problem at the beginning are problems with connecting to the printer. Here you find detailed information how to connect Repetier-Host via Repetier-Server to the printer, which is recommendet.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |